SurfaPore C: waterproofing for cement surfaces NanoPhos

Nanotechnology for cement surfaces, mortar, grout, stucco and natural or artificial stones

SurfaPore ® C LT1
SurfaPore ® C LT4

More details

New

22,08 €

More info

Nanotechnology for cement surfaces, mortar, grout, stucco and natural or artificial stones

Industrial protection for cement and natural stone.  Including tilt slabs, blocks, pavers, plaster and lime plasters, Timaru stone, Hinuera stone.
Average coverage is 9 square metres per litre.  Two coats recommended.Volumes can be purchased in 1, 4

Industrial protection for cement and natural stone.  Including tilt slabs, blocks, pavers, plaster and lime plasters, Timaru stone, Hinuera stone.
Average coverage is 9 square metres per litre.  Two coats recommended.Volumes can be purchased in 1 and 4 litre containers.



Benefits:

  •     Water-based and non-toxic
  •     Environmentally friendly
  •     Prevents efflorescence
  •     Out performs siloxane/silane and acrylics
  •     Does not affect colour or texture
  •     Can be used as a water proofing primer
  •     Will not interfere with paints, plasters or adhesives
  •     Easy, one step application with water clean-up


Applications

Cement walls, floors, retaining walls, concrete blocks and pavers, natural stone work, grout, mortar.  Anywhere cement products need to be protected from moisture and efflorescence.

Why is vapour permeability so important?

SurfaPore C is vapour permeable, or breathable.  When moisture is trapped behind a SurfaPore C modified surface it can evaporate, thus relieving negative capillary pressure which could otherwise degrade the substrate from within by causing swelling, cracking, and warping.

How to Apply

Surface Application: The application surface should be dry and clean. Apply SurfaPore C by using a brush, roller or spraying. No dilution is required. On very absorptive surfaces re-apply within 3 hours. Mixing: Replace 1/3 of water used in your mix with SurfaPore C. Mix well. In any case (surface application or mixing) test results on a small area before full scale application. Maximum water resistance is achieved 24 hours apfter application. Consumption: Estimated coverage is 8-10 m2/L, strongly dependant on the properties of the surface applied.

Physical Properties:  Milky White, Water Emulsion with slight odour and pH = 7.1. Boiling & Flash Point: >100°C Auto Ignition Point: >100°C. Density: 1.01 g.cm-3 Viscosity: 20 mPa.s SurfaPore C is not considered an oxidant.

Safety & Storage:  SurfaPore C contains no hazardous ingre- dients and is water based. VOC Content: 24g/L (EU limit (2010): 40g/L). Not hazardous according to Council Directive 1999/45/EC and its subsequent amendments. Request, read and comprehend the MSDS. Avoid freezing. Expiration Date: Two years after the production date.

Customers who bought this product also bought:

  • SurfaPore ® W NanoSilv

    SurfaPore ®...

    39,83 €

    Wood waterproofingAvailable on 1lt and 4lt

  • SurfaPore M NanoSilv

    SurfaPore M...

    66,04 €

    Waterproofing for marbleAvailable on 1lt and 4lt

  • SurfaPore R NanoSilv

    SurfaPore R...

    21,98 €

    Waterproofing for cottoAvailable on 1lt and 4lt

Download